Category: Engineering
Created by: Manadono
Number of Blossarys: 4
The drag line is the ring of surface damage caused by the cylinder stop pin on most revolvers. It is caused by the pin dragging over the surface of the cylinder as it rotates between shots. The ...
The handle used to charge the firearm, or open the breach to perform safety checks or to remove malfunctioned ammunition. In most cases the charging handle is directly attached to the bolt carrier ...
The cylinder in which ammunition is fired from. The cylinder in most firearms is directly connected to the barrel and holds the cartridge in place as its primer is struck by a hammer or firing pin. ...
The butt-plate is the shaped plate at the very end of the stock, where the shoulder meets the firearm. Most WWII era rifles had wood or metal butt-plates. Due to the lack of funds, many cold-war era ...
The flat surface of the bolt that engages with the rear of the ammunition to both load new rounds into the chamber and secure them in place during firing. The bolt face will have a hole for the ...
The barrel is the tube down which fired ammunition is stabilised before exiting the firearm. In general terms, the longer the barrel, the further the bullet will travel, however there is a point at ...