upload
Baldor Electric Company
Industry: Electrical equipment
Number of terms: 4774
Number of blossaries: 0
Company Profile:
Since there are various ambient temperature conditions a motor might see and different temperature ranges within which motors run and insulation is sensitive to temperature; motor insulation is classified by the temperature ranges at which it can operate for a sustained period of time. When a motor insulation class is labeled on the nameplate the total insulation system is capable of sustained operation at the above temperature.
Industry:Electrical equipment
Since the watt is a relatively small unit of power, the kilowatt (kw), 1,000 watts, is used where larger units of power measurements are desirable.
Industry:Electrical equipment
The steel portion of the rotor and stator cores made up of a series of thin laminations (sheets) which are stacked and fastened together by cleats, rivets or welds. Laminations are used instead of a solid piece in order to reduce eddy-current losses.
Industry:Electrical equipment
Usually refers to AC motors in 5,000 series frames and above and to 500 series frames and larger in DC.
Industry:Electrical equipment
A motor converts electrical energy into a mechanical energy and in so doing, encounters losses. These losses are all the energy that is put into a motor and not transformed to usable power but are converted into heat causing the temperature of the windings and other motor parts to rise.
Industry:Electrical equipment
It is a fundamental principle of a winding that adjacent poles must be wound to give opposite magnetic polarity. This does not mean that the coils actually have to be wound in this direction before being placed into the stator. It does mean that the winding must be connected so that, if the current proceeds through one pole in a clockwise direction, it must proceed through the next pole in a counterclockwise direction. This principle is used to determine the correctness of connection diagrams.
Industry:Electrical equipment
Motors in NEMA 143T to 449T frames.
Industry:Electrical equipment
A device that takes electrical energy and converts it into mechanical energy to turn a shaft.
Industry:Electrical equipment
When two or more DC motors are required to operate in parallel - that is, to drive a common load while sharing the load equally among all motors - they should have speed-torque characteristics which are identical. The greater the speed droop with load, the easier it becomes to parallel motors successfully. It follows that series motors will operate in parallel easier than any other type. Compound motors, which also have drooping speed characteristics (high regulation), will generally parallel without special circuits or equalization. It may be difficult to operate shunt or stabilized-shunt motors in parallel because of their nearly constant speed characteristics. Modifications to the motor control must sometimes be made before these motors will parallel within satisfactory limits.
Industry:Electrical equipment
Indicates the space relationships of windings and changing values of the recurring cycles of A.C. voltages and currents. Due to the positioning (or the phase relationship) of the windings, the various voltages and currents will not be similar in all aspects at any given instant. Each winding will lead or lag another, in position. Each voltage will lead or lag another voltage, in time. Each current will lead or lag another current, in time. The most common power supplies are either single (10) or three phase (with 120 electrical degrees between the 3 phases).
Industry:Electrical equipment